Cari di manual
Atlas Copco MAS GA 18Kompresor sekrup berpelumas oli, hlm. 47 … Next Service
Text on image
(1)
Next service
(2)
Level
(3)
Running Hours
(4)
Actual
In the example … Atlas Copco CD 25+…260+Pengering udara adsorpsi (regenerasi dingin), hlm. 42 … Text on figure
(1)
Service plan
(2)
Level
(3)
Running hours
(4)
Real time
Next Service
Text on … Atlas Copco MAS GA 18Kompresor sekrup berpelumas oli, hlm. 45 … Overview
Text on image
(1)
Overview
(2)
Running Hours
(3)
Real Time Hours
(4)
Reset
Example for service … Atlas Copco CD 25+…260+Pengering udara adsorpsi (regenerasi dingin), hlm. 41 … Overview
Text on figure
(1)
Overview
(2)
Running Hours (green)
(3)
Real Time hours (blue)
Example for service … MAN B&W L23/30H — kartu kerjaMesin diesel bantu empat langkah (genset), hlm. 124 … Cylinder Liner
Cyl. No.
Cyl.liner ident.No.
Running hours
L
e
n
g
t
h
w
i … Atlas Copco CD 25+…260+Pengering udara adsorpsi (regenerasi dingin), hlm. 37 … A number of counters keep
track of the state of the dryer:
• Running hours: counts the operation hours … Atlas Copco MAS GA 18Kompresor sekrup berpelumas oli, hlm. 46 … In the
example above, the compressor was just started up, which means it still has 4000 running hours … MAN B&W L23/30H — kartu kerjaMesin diesel bantu empat langkah (genset), hlm. 210 … This check can be fulfilled after only a few running
hours at max. rpm at full load, but … MAN B&W L23/30H — kartu kerjaMesin diesel bantu empat langkah (genset), hlm. 211 … rod screws
should also be checked, at certain running hours
intervals, see page 500.24.
Fig 4.
325 … TeamTec Golar OG 200Insinerator kapal (minyak lumpur, lumpur limbah dan sampah padat), hlm. 87 … The normal period between grease renewal is 10,000
running hours, but under favourable conditions the bearings will … Hamworthy Super Trident ST6AInstalasi pengolahan limbah biologis, IMO MEPC.2(VI), hlm. 70 … Where running hours and time are quoted, the shorter period is the criterion if the component is a … MAN B&W L23/30H — informasi teknisMesin diesel bantu empat langkah (genset), hlm. 114 … to retighten the roller guide housing every
1000 running hours.
Yours faithfully
New Gasket Material for
Roller Guide … Westfalia OSC 4Separator minyak sentrifugal swabersih, hlm. 81 … After 750 op- 750 First running-in phase Mineral oi!
erating hours completed. IC 100; according to
© Carry … Tanabe LSHC-20B/30A/40AKompresor torak dua tingkat berpendingin udara (darurat / udara kerja), hlm. 8 … Refilling oil
Undue and high load operation under running-in
condition, after putting into initial operation
would shorten … Westfalia OSC 4Separator minyak sentrifugal swabersih, hlm. 80 … 1500 operating hours).
> must display Clearly visible running-in marks.
<<
=
b = min. 1.5-2.5mm
2042014
es … MAN B&W L23/30H — informasi teknisMesin diesel bantu empat langkah (genset), hlm. 118 … 25 % load for 2 hours
50 % load for 2 hours
75 % load for 2 hours
100 % load may … Westfalia OSC 4Separator minyak sentrifugal swabersih, hlm. 43 … The separating period between de-sludgings can be determined by running a
test.
Before starting the test, make … MAN B&W L23/30H — informasi teknisMesin diesel bantu empat langkah (genset), hlm. 74 … In the long run, it is not possible to obtain a secure and
optimal economical running without an … Tanabe LSHC-20B/30A/40AKompresor torak dua tingkat berpendingin udara (darurat / udara kerja), hlm. 34 … please apply synthetic oil after running-in operation for about
300 hours with mineral lubricants.
Replacement of crank … Tanabe VLHH-64A / 74AKompresor torak tipe V tiga tingkat berpendingin udara, hlm. 54 … please apply synthetic oil after running-in operation for about
300 hours with mineral lubricants.
Replacement of crank … Tanabe LSHC-20B/30A/40AKompresor torak dua tingkat berpendingin udara (darurat / udara kerja), hlm. 14 … o Record operating hours every day.
Shutting down
o Set compressor to no-load state.
(refer to Starting … Tanabe VLHH-64A / 74AKompresor torak tipe V tiga tingkat berpendingin udara, hlm. 44 … Rotates handle
* ‘Thereafter replace the oil at intervals of 500 hours.
* Never fail to conduct daily inspection and …