Sludge dosage valve does not start (TeamTec Golar OG 200): apa yang harus dilakukan?

Penyebab: Circulating pump off, chamber below 600 °C, relay, inverter or motor fault. Tindakan: Start the pump, check AL setting and temperature, relays d9/d10, inverter and motor

Sludge dosage valve does not start

TeamTec Golar OG 200, insinerator kapal (minyak lumpur, lumpur limbah dan sampah padat)

Kemungkinan penyebab

Circulating pump off, chamber below 600 °C, relay, inverter or motor fault

Yang harus dilakukan

Start the pump, check AL setting and temperature, relays d9/d10, inverter and motor

Manual produsen, hlm. 45

Lihat rakitan pada model 3D

Gangguan TeamTec Golar OG 200 lainnya

Flame failure alarm at startNo ignition spark, diesel solenoids not opening, dirty nozzle, too much primary air, dirty photo resistor, poor oil Flame failure when stage 2 startsToo much primary air, damper opening too early Low diesel oil pressure alarmNo oil supply, faulty pressure switch b13, pump problem Draught failure alarmLow furnace negative pressure, damper in manual, controller settings, blown fuse, faulty controller or damper motor Flue gas temperature high alarmAbove set value (normal 400 °C), faulty controller u1 or thermocouple Combustion chamber temperature high alarmAbove 1200 °C, faulty controller u2 or thermocouple Sludge dosage valve stops after a whileChamber temperature falls (wet sludge) or motor overload (OL2 on inverter)No flame from the sludge burnerSteam/air solenoid, low atomising pressure, too much water or air, damaged sludge nozzle Low sludge / steam pressure alarmSludge below 0.5–1 bar or steam/air below 6–9 bar, closed valves, faulty switches Flue gas fan does not startTripped breaker e11, contactor, motor or switch

Dari manual produsen “EM-10 INCINERATOR”. Periksa dokumen asli di kapal sebelum bekerja.

Halaman ini diterjemahkan otomatis. Nomor suku cadang, kode, dan halaman sesuai aslinya.