ERR 2 — clock failure (JOWA SEAGUARD): what to do?

Q: ERR 2 — clock failure (JOWA SEAGUARD): what to do?

Cause: Hardware failure. What to do: Switch off, remove the battery from the control unit for 24 h, switch on, set GMT time and date, refit the battery; otherwise replace the CPU board

ERR 2 — clock failure

JOWA SEAGUARD, 15 ppm bilge alarm (ows monitor)

Possible cause

Hardware failure

What to do

Switch off, remove the battery from the control unit for 24 h, switch on, set GMT time and date, refit the battery; otherwise replace the CPU board

Manufacturer's manual, p. 22

See the assembly on the 3D model

Other JOWA SEAGUARD faults

ERR 4 — memory errorMemory card loose or faulty (corroded contacts)ERR 8 — sensor not connectedBroken/loose cable or faulty sensor ERR 10 — sensor cleaning requiredNo clean water, dirty sensor, failed auto-flush, air bubbles, faulty sensor ERR 20 — sensor temperatureTemperature outside +1…+60 °C or faulty sensor ERR 40 — log truncatedLog recording interrupted by power failure ERR 80 — unknown errorSoftware failure or no ID in the Information menu PPM: O/R — out of rangeValue outside 0–30 ppm, sample too dirty, faulty sensor

From the manufacturer's manual “Manual JOWA SEAGUARD”. Check against the original on board before work.

This page was translated automatically from the manual summary. Part numbers, codes and page numbers are as in the original.